Analyses on Heat-Power Decoupling Potential and Energy Consumption Characteristics for CHP Plant Integrated With Heat Pump

doi:10.12096/j.2096-4528.pgt.19073

Power Generation Technology ›› 2019, Vol. 40 ›› Issue (3): 253-257.DOI: 10.12096/j.2096-4528.pgt.19073

• Energy Clean and Efficient Utilization in Coal-fired Power Systems • Previous Articles Next Articles

Analyses on Heat-Power Decoupling Potential and Energy Consumption Characteristics for CHP Plant Integrated With Heat Pump

Zhongqiu LIU¹(),Guozhu ZHANG¹,Yinchen QIU¹,Juntai ZHANG¹,Shan WANG²,Ming LIU²()

¹ Datang(Beijing) Energy Management Co. LTD., Haidian District, Beijing 100097, China
² School of Energy and Power Engineering(Xi'an Jiaotong University), Xi'an 710049, Shaanxi Province, China

Received:2019-05-06 Published:2019-06-30 Online:2019-07-02
Supported by:
National Key Research and Development Program(2018YFB0604405);Shaanxi Province Innovation Capability Support Plan(2018TD-014)

Abstract

Abstract:

The integration of heat pump can realize heat-power decoupling, and would influence the energy consumption characteristics of combined heat and power cogeneration plants (CHP). Therefore, a 350MW CHP unit was taken as a reference case, and the off-design calculation models of CHP unit and the heating calculation models of heat pump were established. The minimum power load rate and the coal consumption rate of the CHP plants with steam extraction and heat pump to supply heat were compared. The influences of the heat pump performance coefficient, the power load rate and the heat load rate on energy consumption characteristics of CHP plants were also studied. Results show that the compression heat pump can save energy on benchmark condition and its power load regulation range is also greater. The coal saving rate increases with the increase of α_COP1 and heat load rate, and decreases as power load rate increases. When the α_COP1 is 6.119, the heat load rate is 2.5, and the electric load rate is 0.8, the coal saving rate is 2.60%.

Key words: heat and power cogeneration, heat pump, heat-power decoupling, power load rate, heat load rate

Zhongqiu LIU,Guozhu ZHANG,Yinchen QIU,Juntai ZHANG,Shan WANG,Ming LIU. Analyses on Heat-Power Decoupling Potential and Energy Consumption Characteristics for CHP Plant Integrated With Heat Pump[J]. Power Generation Technology, 2019, 40(3): 253-257.

References

1	张广才, 周科, 鲁芬, 等. 燃煤机组深度调峰技术探讨[J]. 热力发电, 2017, 49 (9): 17- 23.
2	刘豫龙. 胜利发电厂2号机组变工况运行经济性分析[J]. 洁净煤技术, 2006, (2): 1- 5.
3	王永庆, 张宏, 苏耕, 等. 热电联产机组节能发电组合研究[J]. 电网与清洁能源, 2013, 29 (12): 45- 49.
4	史毅越.抽汽式汽轮机的模型辨识及热电解耦[D].南京:东南大学, 2014.
5	董云风, 吕少胜. 大型热电厂热电解耦方式选择[J]. 工程建设与设计, 2018, (1): 62- 63.
6	李树明, 刘青松, 朱小东, 等. 350MW超临界热电联产机组灵活性改造分析[J]. 发电技术, 2018, 39 (5): 449- 454.
7	苏雪刚, 卢丽坤, 唐卉, 等. 大型蓄热水罐在热电解耦中的应用[J]. 锅炉制造, 2018, (1): 46- 18.
8	李奕. 2×300 MW汽轮机双机循环水余热供热系统[J]. 发电技术, 2018, 39 (3): 244- 248.
9	王长河, 陈光, 王宝玉. 基于吸收式热泵的大型火电厂冷凝废热回收技术研究[J]. 制冷空调与电力机械, 2011, (4): 67.
10	费盼峰, 孙士恩, 冯亦武, 等. 联合循环电厂大型吸收式热泵余热回收系统在线性能检测的研究与应用[J]. 发电与空调, 2014, 32 (1): 11- 15.
11	张学镭, 陈海平. 回收循环水余热的热泵供热系统热力性能分析[J]. 中国电机工程学报, 2013, 33 (8): 1- 8.
12	袁周华. 基于洗浴废水热能梯度利用的高效节能制热水系统[J]. 可再生能源, 2016, 34 (4): 579- 582.
13	吕太, 刘玲玲. 热泵技术回收电厂冷凝热供热方案研究[J]. 东北电力大学学报, 2011, 31 (1): 6- 10.
14	王力彪, 李染生, 王斌, 等. 基于吸收式热泵的循环水余热利用技术在大型抽凝机组热电联产中的应用[J]. 汽轮机技术, 2011, 53 (6): 470- 472.
15	刘军, 刘海生. 压缩式热泵热水机组在中央热水系统中的应用实例[J]. 能源技术, 2004, 25 (3): 112- 114.
16	朱斌帅, 张赟. 电厂集中供热领域中吸收式热泵与压缩式热泵的经济性比较[J]. 节能技术, 2016, 34 (5): 440- 443.
17	林万超. 火电厂热力系统节能理论[M]. 西安: 西安交通大学出版社, 1994: 80- 91.
18	严俊杰, 邢秦安, 林万超, 等. 火电厂热力系统经济性诊断理论及应用[M]. 西安: 西安交通大学出版社, 2008: 3- 26.

[1]	Kai XUE, Yihan WANG, Heng CHEN, Gang XU, Jing LEI. Thermodynamic Performance Analysis of a Parabolic Trough Solar-assisted Biomass-fired Cogeneration System [J]. Power Generation Technology, 2021, 42(6): 653-664.
[2]	Junbo ZHANG,Xu JIN,Zhongyan LIU,Deyong CHE,Jun SUI. Review on Advanced Technology for Waste Heat Recovery of Absorption Heat Pump [J]. Power Generation Technology, 2020, 41(3): 269-280.
[3]	Yunchao LI,Dazhou ZHAO,Bo LIU,He ZHANG,Hongtao MA,Xin TIAN. Status and Prospect of Waste Heat Utilization in Power Plant [J]. Power Generation Technology, 2019, 40(3): 270-275.
[4]	Yongsheng TAN. Performance Analysis of the DCCHP Exhaust Waste Heat Coupled Air Source Heat Pump System [J]. Power Generation Technology, 2018, 39(6): 526-532.
[5]	Yi LI. Heat Supply System of 2×300MW Units' Circulating Water Waste Heat [J]. Power Generation Technology, 2018, 39(3): 244-248.
[6]	ZHU Hongjin. Energy Saving Technology of Air Conditioning System in Application Area of Hospital Renovation Project [J]. Power Generation Technology, 2017, 38(6): 74-79,89.
[7]	PENG Hao. Design Analysis of Ground Source Heat Pump System for Store Project [J]. Power Generation Technology, 2017, 38(5): 90-94.
[8]	YAN Wei-dong, TONG Chu, HAN Xu, ZHANG Yu-xiao. Preliminary Exploration of Compound Fresh Air Heat Recovery System and Research on the Influence of Indoor Thermal and Wet Environment [J]. Power Generation Technology, 2017, 38(4): 67-72.
[9]	FA Zheng-hao. River-water Temperature Analysis and Energy Consumption Analysis of the Huangpu River River-water Source Heat Pump in Cooling Season [J]. Power Generation Technology, 2017, 38(2): 88-91.
[10]	PAN Zu-dong, WANG Zhi-yi, YANG Song-jie, WANG Xin-min. Economic Analysis of Condensing Exhaust Air Heat Recovery Fresh Air All-in-one Unit in Hangzhou Area [J]. Power Generation Technology, 2017, 38(2): 65-68.
[11]	HOU Hui-qin. Choice of the Cold and Heat Source for Four-pipe Water System of the Hospital Clean Operating Room [J]. Power Generation Technology, 2017, 38(1): 82-85.

Analyses on Heat-Power Decoupling Potential and Energy Consumption Characteristics for CHP Plant Integrated With Heat Pump

RichHTML

PDF (PC)

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 11

Recommended Articles

Metrics

Comments